SNIPER 2 EFI - Black - BLE / PDM / HyperSpark Master Kit Bundle - Bluetooth Module service only available within the USA and Canada.

The #1 Selling EFI conversion just got better…again! We are bundling some of our top-selling Sniper 2 packages and passing along a savings of up to $180! Available for small-block Chevrolet, Big-Block Chevrolet, and 8.2-inch deck small-block Ford (5.0 base), these kits include a Hyperspark distributor, coil, and Hyperspark 2 ignition box. Coupled with a Bluetooth module, Power Distribution Module (PDM), and either a base or Master (in-line fuel system) Sniper 2 kit, these are the most complete Sniper EFI conversion kits ever offered by Holley. The PDM module was specifically designed to provide the easiest wiring experience for Sniper 2 kits that are paired with a Hyperspark ignition. Simply slide the stripped wire ends under the positive lock connector and tighten down the set screw. Battery and a switched 12-volt source are all that's required from your vehicle to power the PDM and your Sniper 2 Hyperspark Bundle. Make your classic drive like a modern fuel-injected vehicle, including easy cold starts, smooth drivability, and improved fuel economy! Sniper 2 is designed to be installed at home in your garage with limited tools and the support of Holley's comprehensive installation manual and videos. The user-friendly setup wizard allows you to answer a few simple questions about your engine and the system will begin self-tuning with no laptop or tuning experience required. If you're looking for a high-performance fuel injection system that delivers power, efficiency, and ease of use, look no further than the Sniper 2 EFI. It’s a single click away! Take full control and make the conversion to EFI with a Sniper 2 EFI Hyperspark Ignition Bundle!

Features:

  • Hyperspark Ignition:
  • The billet aluminum Hall Effect crank trigger sensor housing distributor plugs directly into the Sniper 2 main harness and provides a noise-free RPM signal to the Sniper 2 ECU
  • The HyperSpark 2 ignition box keeps all the features of its predecessor in a more compact design. It offers a clean installation, precise timing control, and consistent spark energy from idle to redline for optimal performance.
  • The included HyperSpark ignition coil features an integrated coil mounting bracket and connects directly to your Sniper 2 EFI Main Harness, removing any potential wiring confusion.
  • Sniper 2 Kits:
  • Sniper 2 EFI Bundles include: Power Distribution Module (PDM), HyperSpark 2 ignition Box, coil, and a Chevrolet or Ford distributor depending on your application
  • Available with or without fuel system: The complete fuel system consists of: 20 ft. of 3/8 in. Vapor Guard fuel hose, fuel pump, fuel pressure regulator, filters, necessary hardware, and bulkhead fitting to return fuel into the tank
  • The Sniper 2 Bluetooth module turns your iOS or Android phone into a tuning and monitoring interface. Just answer a few questions about your engine in the calibration wizard, and you'll get a base map to start self-tuning—no laptop needed.
  • The Sniper Power Distribution Module (PDM) simplifies powering your system with its compact, rugged, and reliable design. With easy connections and no need for configuration, installation is quick and straightforward.
  • Supports up to 650hp naturally aspirated or 575hp on boost with four 100 lb/hr injectors
  • Next generation ECU features improved RF noise and interference resistance (stands up to old car wiring, noisy alternators, faulty plug wires)
  • Redesigned throttle shaft and plate geometry for a smoother throttle feel
  • Integrated transmission kick down provisions for GM TH350/400, 200-4R/700R4 and Ford C4/C6 applications (Sniper 2 Electronic Transmission Control Module available separately)
  • For a full list of features, visit our website.

Specs:

Accelerometer Support No
Boost Control No
Brand Holley Sniper EFI
CAN-BUS Support Yes
CFM 800
Coast Guard Approved No
Coil Per Cylinder Ignition Support No
Datalogging Support Yes
Distributor Included Chevrolet Big Block, Chevrolet Small Block, Yes
  Chevrolet Big/Small Block
Dry Nitrous Control No
e85 Support No
EGT Support No
Emission Code 3
Finish Black
Flange Style 4150
Forced Induction Support Yes
Fuel Filter Included Yes
Fuel Hose Included Yes
Fuel Injectors Included Yes
Fuel Pressure 58.5 PSI
Fuel Pressure Regulator Included Yes
Fuel Pump Flow Rating 240 LPH
Fuel Pump Included Yes
Fuel Pump Type Inline
Fuel System Master Kit
Grade Type Performance
Height 3.28"
Hyperspark Ignition Kit Chevrolet Big/Small Block
Ignition Timing Control Yes
Individual Cylinder Fuel Corrections No
Injector Size 100 lb/hr @ 58.5 PSI
Inlet / Outlet Size 9/16-18 Female O-Ring (AN 6)
Intake Manifold Included No
Knock Retard Support No
MAP Sensor 2 Bar
Max Horsepower Rating 650 Naturally Aspirated
Model 4150 EFI Conversion Throttle Body
Multi-Stage Nitrous Control No
PDM Yes
Power Distribution Module Yes
Product Type Sniper EFI
Progressive Nitrous Control No
Self-Tuning Yes
Throttle Position Sensor Included Yes
Traction Control Support No
Transmission All
User Interface Bluetooth Module
User-Tuneable Yes
Warranty Two Year Standard, Extended Via Product Registration
Wet Nitrous Control No
UPC 090127866368
Part Number 550-511-BPK-SBC
SKU 550-511-BPK-SBC
Barcode # 90127866368
Brand Holley Sniper
Shipping Weight 15.2800kg
Shipping Width 0.430m
Shipping Height 0.470m
Shipping Length 0.610m

Be The First To Review This Product!

Help other Superior Auto Parts users shop smarter by writing reviews for products you have purchased.

Write a product review

More From This Category